__ Summary and Contributions__: The explicit similarities between the objects are not always available for clustering. This paper provides a method to cluster objects, when only the ordinal comparisons are available, such as “object i is more similar to object j than to k”. It estimates a pairwise similarity matrix from the comparisons before using a clustering method based on semi-definite programming (SDP). It also theoretically shows that its approach can exactly recover a planted clustering using a near-optimal number of passive comparisons. The theoretical finding is validated on real data.
---- Update ---
The authors have adequately clarified the questions. After going through the rebuttal, this helps in improving my confidence score from 3 to 4.

__ Strengths__: Considering a planted model for standard clustering , this paper shows that, when the number of clusters k is constant, Ω (n(ln n)^2) passive triplets or quadruplets are sufficient for exact recovery, which is comparable to the number of active comparisons (Ω (n (ln n))).
This paper proposes the first analysis that considers and shows the impact of both the observation error and intrinsic noise on the number of passive comparisons.
This paper proposes a new similarity function whose construction is more efficient than previous kernels.
This paper proves a generic theoretical guarantee that holds for any similarity matrix and, thus that could be of interest beyond the comparison based setting.

__ Weaknesses__: No

__ Correctness__: No errors are found.

__ Clarity__: This paper is well written in general.

__ Relation to Prior Work__: The dicussion of prior work is adequate.
The paper uses the SDP approach for clustering from similarity matrices by (Yan et al 2018; Chen and Yang 2020). The proof of Proposition 1 is adapted from Yan et al. (2018) , but proves the uniqueness of X* which was not done in the previous work.
It requires significantly less passive comparisons comparing to previous work (Ghoshdastidar et al. 2019; Emamjomeh-Zadeh and Kempe, 2018).
It discuss that most of previous analyses of SDP clustering either assume sub-Gaussian data (Yan and Sarkar, 2016) or consider similarity matrices with independence assumptions (Chen and Xu, 2014; Yan et al., 2018), while it is not required in this paper.

__ Reproducibility__: Yes

__ Additional Feedback__: It may be better to provide more information on the datasets (MNIST AND Food) used in the experiment section.
It may be better to descrite the full algorithm proposed in the main text.

__ Summary and Contributions__: This paper studies comparison-based clustering from a planted-clustering perspective, developing methods that are nearly optimal when the data is generated by the planted clustering model, a generative model similar to the planted partition (aka SBM) random graph model. The work introduces two kernels, AddS-3 and AddS-4, that summarize the information contained in triplet or quadlet data (respectively) in an n x n matrix S. The paper then shows that when the triplet/quadlet data is generated under the model, the planted clustering is recovered.
The solution approach, based on an SDP, borrows heavily from analogous existing methods for studying SBMs, but that is OK, this is a nice import to comparison-based clustering, and there is still significant technical novelty. See, for example, the uniqueness result in Proposition 1.
The paper validates the efficiency of the methods on synthetic data, then on “semi-synthetic data” (MNIST data, with noise added to similarities from an embedding), then real data. The results on the real data are poor, but that may be amendable with more work to e.g. borrow from extensions in the SBM literature.
Update: I thank the authors for a thoughtful response letter.

__ Strengths__: + The paper is well written, with clear theorem statements, solid coverage of the literature, and well-documented empirics.
+ The synthetic, semi-synthetic, and real data empirics should be commended for a paper that is otherwise quite focused on theory.
+ The result is important/surprising, that at least under the planted model, the number of triplet/quadlet comparisons to achieve recovering of a planted clustering is less than expected.

__ Weaknesses__: - The empirical results for real (car) data are quite weak, likely due to the planted clustering model being a poor fit to the data. But this could potentially be addressed by considering variations on the model that do a better job of modeling the data.

__ Correctness__: They appear to be correct, though the paper is hard to fully digest without relying on the appendix, even omitting the proofs. Some further details could be provided on for the MNIST data (1v7 and full-10) on how the comparison triplets/quadlets were generated. I assume triplets/quadlets were selected uniformly at random, with replacement, using the Gaussian similarity described in the appendix. What happens if the triplets/quadlets aren't uniformly at random, but biased towards certain subsets? What happens if the "noise" is much more complicated than Gaussian, e.g. a mixture of populations that have different perceptions of the latent space?

__ Clarity__: Yes.

__ Relation to Prior Work__: Yes.

__ Reproducibility__: Yes

__ Additional Feedback__: The kernel representations AddS-3 and AddS-4 can be thought of, I think, as “all the information” when the data generating process is the block-based model in Section 2. If those are the true generating processes for triplets/quadlets, are these S then "sufficient statistic" of the model somehow? I don't know quite how to formalize that question, but there is some work on (minimal) sufficient statistics for the SBM that might help guide the authors here. It would make the use of AddS-3/4 much more intuitive.
Further, I'll reiterate my main worry with the work, that the assumptions of the model are strong and the SDP algorithm fails when model is badly misspecified. Some thoughts on how robust different SBM-recovery algorithms are is covered in Moitra et al. (2016) "How Robust are Reconstruction Thresholds for Community
Detection?", where SDP-based methods generally do well.

__ Summary and Contributions__: Usual clustering algorithms use similarity measures between pairs
of data items. This paper considers the clustering problem when a
similarity measure is not available; instead, only comparisons of
the form "item i is more similar to item j than item k" (triples)
or "items i and j are more similar to each other than items p and
q" (quadruples) are available. It is also assumed that the clustering
must be done in the "passive mode"; that is, the set of triples
and quadruples is given in advance and that no new queries (for
triple or quadruple comparisons) can be issued by an algorithm.
The paper also considers the case where the comparisons are incorrect
with a certain probability. (This can happen if the comparisons are
generated by means such as crowd sourcing.) The paper uses the
results of the comparisons to construct a similarity matrix for the
data items and construct a clustering. It is shown that the number
of triples/quadruples used to recover clusters under the planted
cluster model is substantially smaller than previous work. An
extensive set of experimental results are presented in the main
paper and the supplement to validate the theoretical results.
Update: This reviewer went through the other reviews and the author feedback. The author(s) has (have) adequately addressed all the points raised by the reviewers. This reviewer feels more confident about the quality of the paper. As a result, the reviewer
has updated the confidence score from 3 to 4.

__ Strengths__: -- Improved upper bounds on the number of comparisons needed
under the passive comparison model. (Recall that the model
assumes that the comparisons may be incorrect with a small
probability.) The paper also provides a very good discussion
of prior work and an extensive list of references.
-- Non-trivial theoretical results that prove how a similarity matrix
can be constructed from comparisons and a planted clustering can be
recovered.
-- The experimental results to validate the theoretical findings
are comprehensive.

__ Weaknesses__: There are two minor weaknesses. First, in many places, the paper uses
the lower bound notation (i.e., the \Omega function) when presenting
upper bounds. In a few places, there is also the opposite usage
(i.e., upper bound notation is used when a lower bound is indicated).
Some of these are pointed out in the "Additional feedback" section.
In a few places, the authors need to slightly improve the presentation
for readers to clearly understand the material.

__ Correctness__: As far this reviewer can tell, the theoretical results seem correct
and the experimental methodology seems sound.

__ Clarity__: The paper is written very well. Only a few minor clarifications (indicated in
the "Additional feedback" section) are needed.

__ Relation to Prior Work__: The paper provides a very good discussion of prior work and clearly points
out the new contributions relative to existing work.

__ Reproducibility__: Yes

__ Additional Feedback__: The topic of comparison-based clustering is attracting attention in the
literature. This paper makes a very useful contribution to the topic
by considering the passive comparisons model and obtaining better upper
bounds on the number of comparisons used to carry out clustering. Overall,
the paper is well written. It is interesting to see that for the Food data
set, the experiments suggest the possibility that of an alternative natural
clustering with two clusters instead of the assumed number of three clusters.
The paper also discusses prior work in detail and clearly brings out
the new contributions.
I. Technical suggestions:
(a) In many places, the paper uses the lower bound notation (i.e.,
the \Omega function) when presenting upper bounds. As an example,
on page 2, line 65, the authors say "... \Omega(n (\ln{n})^2) passive
triplets or quadruples are sufficient for exact recovery" when the
intention is to say that O(n (\ln{n})^2) passive triples or quadruples
are sufficient. (This type of error occurs on page 2, 5, 6 and 8.) In
a few places, there is also the opposite usage; that is, upper bound
notation is used when a lower bound is indicated. As an example,
on page 2, line 88, the authors say "... require up to O(n) passes"
where they want to convey that \Omega(n) passes are required.
(b) Page 2, lines 68--69: The meaning of the sentence "Furthermore, it is
near-optimal ... at least \Omega(n) comparisons" is not clear.
(c) Page 3, Equation (1): Why do you say that you have accesses to triplets
"or" quadruples? In general, your algorithm can use both triples and quadruples.
(d) Page 3, lines 104--106: The reason for assumption that when a
triple i, j, r is observed, either (i, j, r) \in T or (i, r, j) \in
T is not clear. You also use a similar assumption about quadruples.
(Since you are using the passive comparison mode, you have no control
over which triples or quadruples appear in the input.)
(e) Page 4, line 160: The use of \Sigma as a k by k matrix is likely
to cause confusion because you are also using in terms of the
form \Sigma_{\ell,\ell'} which looks like a summation rather than an entry
in matrix. It is better to use a different symbol for the k by k matrix.
(f) Page 5, line 199: Should the excess value of inter-cluster similarity
be \Omega(p \epsilon \delta {n \choose 2}) instead of just
p \epsilon \delta {n \choose 2}? (The \Omega seems necessary for consistency
with the similar quantity for quadruples used in line 204 on the same page.)
(g) Page 6, Remark 1: This remark also seems to need the assumption regarding
similar cluster sizes. This should be checked.
(h) Page 7, line 276: it would be better to indicate whether k_{\lambda}
should be defined as the ceiling or floor function of trace(X_{\lambda}).
(i) Page 7, last paragraph: You state the bound number of comparisons as
"n (\ln{n})^{4.5}", etc. It is better to add a note earlier in the paper
to indicate that such bounds refer to the ceiling of the indicated functions.
II. Typos and stylistic suggestions:
(a) Page 2, line 46: "exists" ---> "exist"
(b) Page 2, line 85: "type" ---> "types"
(c) Page 3, line 132: Insert "satisfy" after the word "means"
(d) Page 3, line 135: "identify the number of" ---> "obtain bounds on"
(e) Page 4, line 183: "makes" ---> "make"
After author feedback: I thank the authors for the feedback. I have read through the other reviews and the author feedback. My overall score remains unchanged.